Aprimatic APE-152/6060 - T4 The universal 4-channel radio remote control for automations

Aprimatic APE-152/6060 - T4 The universal 4-channel radio remote control for automations

T4 is a universal 4-channel quartz-controlled radio remote control that allows you to manage compatible automations, with the possibility of duplicating the codes of radio controls from other brands.

Main features:

• 4 channels: control up to 4 independent automatic devices.
• Frequency: 27 MHz - 40 MHz.
• Duplication: copies the codes of radio controls of other brands, allowing one radio control to be used for several automations.
• Battery: 1x 12V 23A (included).
• Dimensions: 37 x 62 x 14 mm.
• Weight: 30 g.
• Grade of protection: IP52 (resistant to dust and water jets).
• Operating temperature: -10°C / +50°C.

• The TQ4 allows you to duplicate remote control codes from other brands, making it a universal remote control compatible with a wide range of automations. Duplication is quick and easy, and each key on the TQ4 can be associated with a key on the original radio control.

• Step 1: Press and hold button 1 of the TQ4, then press button 2 four times. The blue LED will begin to flash slowly.
• Step 2: Release the buttons and place the remote control to be duplicated perpendicular to the TQ4 on the left side.
• Step 3: Press and hold the button on the original remote control until the blue LED on the TQ4 flashes quickly, then release it.
• Step 4: Now press the button on the TQ4 into which you wish to enter the original code you have just learned and wait for the blue LED to go out. The copy has been successfully copied.
• Step 5: Now adjust the signal strength with the appropriate tool by acting on the compensator inside the remote control (see the section entitled SETTING THE RADIOCOMMANDS).

• Blue LED flashing fast: Low battery, replace battery.
• Blue LED flashes slowly while copying:
• Check the compatibility of the original remote control.
• Replace the battery of the original remote control.
• Contact service.
• Reduced range:
• Calibrate the radio control (see section on RADIO CONTROLS CALIBRATION).
• Make sure that the automation antenna is of the same frequency as the copied radio control and is installed away from walls and metal parts.