Tecnel TE-150-24TRI - 150W 24Vdc Constant Voltage LED Strip Power Supply, Push + Triac/Mosfet Dimmable

Constant voltage power supply for 24Vdc LED strips, with a maximum output power of 150W. The Tecnel TE-150-24TRI is designed to power single-colour LED strips and other 24Vdc constant voltage LED lighting products, allowing brightness adjustment through phase-cut dimmers or normally open push buttons.

Thanks to its compatibility with Triac/Mosfet dimmers, Leading Edge and Trailing Edge technology, it can be used with home automation dimmer actuators with phase-cut output, recessed dimmers, DIN rail dimmers, push-button controls, FM remote controls and compatible Bluetooth, Bluetooth Mesh or Wi-Fi smart systems.

Dimming is managed directly on the 230Vac power supply line, without the need for additional control cables. This makes it particularly suitable for existing installations and renovation projects, where adding extra wiring can be difficult.

Main features

Constant voltage power supply for LED strips
24Vdc output
Maximum power 150W
Triac/Mosfet phase-cut dimmable
Direct control also via normally open push buttons
Compatible with Leading Edge and Trailing Edge dimmers
Ideal for 24Vdc single-colour LED strips
Suitable for home automation actuators with phase-cut dimmer output
Terminal block connection
Indoor use, IP20 protection rating
Self-resetting electronic protections

Technical data

Code: TE-150-24TRI
Category: Lighting / Constant Voltage LED Power Supplies / Dimmable LED Power Supplies
Technology: Dimmable power supply
Dimming type: Phase-cut, Push
Control signal: Triac/Mosfet
Input voltage: 200-240Vac 50/60Hz
Output voltage: 24Vdc
Power: 150W
Protection rating: IP20
Connection type: Terminal blocks
Dimensions: 305 x 44 x 30 mm
Use: Indoor

Integrated protections

The power supply is protected against open circuit, short circuit, overload and overtemperature. When a protection is triggered, the power supply is interrupted and automatically restored once the cause of the fault has been removed.

Installation

The device is suitable exclusively for LED strips and LED lighting products powered by 24Vdc constant voltage. Polarity must be respected during connection, according to the wiring diagram on the product.

The power supply is intended for indoor use only, with IP20 protection rating. To comply with CE marking requirements, the maximum cable length between the power supply and the LEDs must not exceed 2 metres.

Warning for push-button control

When using direct control with normally open push buttons, it is recommended to install a switch in series with the 230Vac phase supply, so that the power supply can be disconnected before leaving the room for long periods.

Reference standards

EN61347-1
EN61347-2-13
EN61000-3-2
EN61000-3-3
EN61000-4-2/3/4/5/6/8/11
EN61547